Search results

Frame mounted with good hardware, never heard of or seen one damaged. I personally have been mean to mine, they’ve never let me down.

Start over with a new dealer that has a paint shop. They’ll look the entire ride over then submit a claim.

Great looking “New Rig”!!

This was an original design, and it wasn’t rated for a 35” + tire…I tracked down a couple of people who bought one of these. Amazon is their distributor, their website looked like you could by direct, but I did Amazon for the return policy. The upright has two legs that support the tire much...

Thanks I’ve been eyeing those as well.

did you check to see if the top four fuses at the top of the diagram are seated properly?

Chris is right, that is controlled at the door latch. I’m wondering if a Tazer would have that ability to turn it on/off?

I’ve got a 2020 sport, I’ve replaced the head unit as well. Unplug the door harness but don’t remove the door or open the door. if you do that does the power time out? With the harness still unplugged open the door, does that power it down ?

How’s the ride with these new shocks?

You might check into high quality stainless steel braided brake lines. Almost no line expansion compared to the stock rubber ones. Also do you have an in dash break controller for your trailer? if not I would put one in. It made a huge difference on mine pulling my 18’ haul trailer and my boat...

What’s in your product? 18 gauge steel?

What were you driving on your trip?

I really like this product, maybe on your 2.0 version, hinge those ladders just at the bed top and make them fold upward into the upper part of the ladder and lock in place until needed. Less likely to get torn off out in the rocks, tight trails and brush.

Great Idea! The only mod I’d recommend is trimming back your base platform where you have the forward facing fridges tie downs to avoid ankle damage when the seat is in the normal people hauling position. That area where you step into the back seat is very tight, especially with my big feet.

Ok a few questions, 1. It’s a burrito cooker!, a little hinged grill to lock and hold them down on top of that plate. My 3.6 will bring well done in less than 2 miles. 2. aluminum plate aka heat sink over my engine, whatevers sitting on it or by it better have tinfoil panties. 3. the only main...

Haven’t tried one, but a couple of comments. Website says the front bumpers are constructed with 5/32” steel, the site doesn’t say if the winch plate is thicker than 5/32”… that is not enough for a 12K winch! At a minimum with that winch it better have at least 1/4” steel base plate to sit on...

Bill, Hang in there for you and the wife, better days are just around the corner!

Upholstery shops use steam to manage and move rag top material around during installations, this might encourage your cloths pins fix?

Is there a metal or synthetic structural piece inside of that edge? Or is it all material and stitching?