My new Honda Accord doesn't even come with Navigation. No need any more with the options available on Car Play Android auto? I updated the Nav. in my gladiator then kicked myself for burning money.
Put 35s on a stock 2020 Overland. Went down the toad ok but rubbed when i went offroad. Added a 2.5 inch Mopar lift after and 55K miles later all is still well
Those are non-Rubicon fenders. I have an overland. The fenders are shorter and narrower. Only Rubicon‘s and Mojave go up to the hood line when you look at them from the side.
I have red hooks, front and rear, and the name of the truck in the same font as the Rubicon. I did it because my color...
Being a bit proactive since its freezing out, but I'm looking at ways to keep cool in the Texas heat this summer while camping. Looked at the Eco Flow Wave 2, The Ice Cove, the Zero Breeze Mark 2 and Mark 3. Looks like everyone on Marketplace and eBay is getting ride of the Zero Breeze Mark 2...
Just Purchased the Bluetti Charger 1, which looks like a much simpler install. Just had "P" Cancer surgery so it will be a month or two before I proceed with an install. So I will follow along here.!
I was the poster child for the Shiprock with rails on a Roll n Lock and finally went with a 23Zero, A2. It mounted easily, and bolted right up with no adapters. Plus it just fits tight in the garage.
My Mopar extended Warranty covered everything except Batteries and Brakes. Stating that if replacement parts were needed, it will cover the part and the labor. They covered one tie rod, and the Mopar Steering stabilizer. I wanted to upgrade the parts and pay the difference, but the warranty...
Your Right, “joint” was a bad choice of words. Always just below the coupling, same as you.
O Just went to O’Riley’s and picked up three feet of higher quality line for under $4
First time seeing this thread. I'm in North Texas and rarely see a freeze. I have had them for two years and they dump a lot of fluid and work great when they are not broke. Mine have snapped twice, at the joint when connecting them per the instructions. Just did it again, but I cant work on...