Search results

I did MB Quart for all internal soeakers and a Kicker 10” powered behing the rear seat. It slunds GREAT!

Extreme terrain offers a metal roof molle system that can accommodate long guns with a strap. They also have a gun rack system that mounts in the top as a slide lock system and holds 1-2 long guns with built in holders that are padded.

^ Just after the divorce :) Kidding…. I hope…. just got the halo LED headlights installed tonight. Rear rack for top of camper shell should be here tomorrow…the I think I am done for a bit…

Ended up doing a 1.5” terraflex front lift and .75” in the rear of the Mojave. Will be doing my new halo headlights tonight.

I will add… i have the Mojave…the seats are fantastic. The radio…. After some minor speaker replacements and adding a Kicker 10” powered sub my 8” head unit ROCKS. life is too short to be unhappy though. Good luck!

Thanks! Just ordered the rubber stripping

Ok! Found them! Company is Front Runner. Nust measure the length that you want and easy straight forward install. See below the rear on the camper top.

I just orderd a set as well. They are very easy to install. Will take less than 20 mins.

Welcome to the world of having every paycheck go to crap you never thought you would need-want.

Ok. I ordered a set thats 52”. I will report back on IF they work and will gove the details.

Just to be clear: I would like the full Cross load bars with mounts that go into that roof mounted track. Looking for options (manufactures) that others are using

There has to be a cross bar setup that instals directly to the mounted rail… hopefully someone here knows of a good one.

I have have the A.R.E CX camper shell that came with the roof rails installed (has a channel for t-nuts). Question: Where / what cross bars should i get? I camt seem to locate any that mount to that rail system easily. Thans for the help! Below is a picture of the rails.

JaxMax, Yes very close like maybe an inch or so away. It almost looks like one full piece. That was one of the reasons i was looking for the CX series but just did not want to spend $4k. Got bored in the garage after cleaning the inside and installed these on the hood…..

All done. Cleaned inside and installed all mounting brackets. I am really happy with it.

^ Do it! Do a good prep and it will go on easily. I used a small 6 gallon air tank and it was easy. I will be doing my hard top over the break as well. I like the look of the camper shell soo much i want my hard top to match.

Will be on about 6 pm. Got some buddies coming over to help lift it and get it centered.

Tape off and installing some rubber gaskets/stripping material. Still going to add some to the bottom so there is no way if could scratch the bed.

Mine pictured is the CX series by A.R.E

The key not having “tiger” stripes is on your last lay of the spray be elevated and mist it. That will elinate any striping.