Search results

Can we see a pic taken from 90* so we see what the side of the truck looks like with them. Thanks

Unless you have a big brake kit, a 17” spare wheel is the way to go. Cheap and plentiful. A half worn 35” tire good enough for a spare should be even easier to find.

The angled down step is far from the limiting factor on ground clearance.

Rock Hard 4x4 angled down is what I have. Worth every penny!

No concern about reduced airflow and cooling? Some big lights!

Thanks. It’s powdercoat not paint. my local powdercoater has a special color mixed up that matches Mopar gator almost perfectly.

Going in for regear Monday. Got my motobilt diff covers back from powder coat in anticipation. Gator diffs to match body color

Doh! What did it sound like then? J/k sorry about yours. Bad set up, bad parts?

Glad so many here love them and are ready to jump. I will help you by partially offsetting the cost. IM me and we can make a deal on your factory LED tails. Seriously.

This is highly relevant to me as well. Consider this a tag.

Anyone have part numbers for the bed sliders (behind the rear wheels)? I think there’s 2 pieces on each side. Ideas on cost? I assume they can be mounted on non Rubi glads?

yes please!

Move the rear axle a foot forward on the bottom pic so it’s roughly in the same location as the bobbed one in the first pic.

I have a plug thAt requires a 9/16 Allen wrench to tighten. Problem is that when I had the covers powder coated they didn’t do a great job protecting the threads in the cover so I now can’t get the plug started into the bung

I’m cool with what the OP wants to do if it fits his needs. Personally I love the “bobbed” gladiators with the excess bed length lopped off. If I could get a 2 door JT with a bobbed bed but the same wheel base so I still had roughly the same bed length only all of it forward of the rear axle I...

Motobilt replacement diff covers. The hole measures 58/64”. The plug that screws into it measures 1.04”. The back of the bung is marked as pictured, 3/4. What size tap do I need to run thru it to clean the powder coating out of the threads? Pipe threading measurements is Chinese arithmetic to...

Truth. I have the new gear sitting in a box in my garage and now I cannot decide if I want to get it installed. I have the synergy brace also ready to install. I may just do the brace and see if there’s much improvement. I don’t think mine is horrible but if it was tighter that would be worthwhile.

Clayton Off-road 2.5” Overland Plus

The strut channel came from McMaster Carr.