There are many threads on this…..
My personal experience is this though. My 23 Mojave was bought post recall. Supposedly it had a new clutch and software reprogram. The bolts on my transmission and crossmember showed 0 signs of being removed.
My clutch felt like crap compared to any manual id...
I did use JScan not that should matter to set the tire size. But with them set little smaller then actual it’s doing great. I tried everything I would normally do from 4Hi,4low, on and off road and aired up or down.
Hope your experience is good and you don’t even have to bother with the BS I did.
Well back home.
Roughly 500 mile round trip with lots of beach driving in 4Hi aired down to 16-18psi and then about 20 min of stop and go traffic on the interstate on way home due to accident.
So had plenty opportunity to use the clutch and set a service transmission light for sure and with...
Preliminary update.
450 miles since everything was reset and changed and I’ve been out on the beach in 4Hi yesterday. No issues “yet”.
maybe onto something with changing the tires size just. Little smaller than actual measurement. I don’t know. But I’m aired down to 17psi right now and so far...
About 5 days ago I dropped the tire size in the computer to 34”.
Mind you they are 35x11.50r17 nitto trail grapplers. Factory spec is 34.76 inflated which I ran in the computer since new.
They measured about 34.5” on my vehicle with my psi which I tried this size for a short time and the issue...
It says 2018 wrangler but is the same process and mirrors tazer directions.
Disconnect the negative terminals for 1min
Drive it and meet the conditions
After I’d clear codes if any but I haven’t had any from this.
if you use Tazer or JScan you’ll still need to do the relearn see image.
If you don’t it can cause issues not sure if it will set the service transmission light but will cause problems. So this may or may not be what caused your current problem.
Well since it went in for the recall they will reset it no doubt and get it back to you in working condition.
unfortunately it’s a good chance it will
Come back on while not everyone is getting limp mode when the lights on.
If you have or get JScan setup you can reset it on your own until it’s...
I leave the cables plugged in unless I take it to the dealer for work,but I would unplug the Bluetooth adapter as it stays powered on and could overtime drain your battery.
I’m loving the act clutch ?
Unfortunetly I’m very doubtful about your service transmission light the clutch isn’t gonna...