Search results

I bent one of my oem rear sway bar links and bent it back. Decided it was a matter of time till I actually break it. Decided to order the rockjock anti rock rear swaybar. The install is pretty basic, just watch a few videos and you will be fine. The hardest part was getting the rod brackets into...

Once I pressurized the system then let it idle for a few minutes, I was 1-quart low actually. I drove it around a bit and let it sit again. Still one quart low so I topped it off. Total system holds 6 quarts, I will let it sit for a few days to see if the level goes over.

Got mine installed to day. Oil pressure seems to be the same as before. No warning lights or any issues so far. I'll run it and report back.

I posted the 8speed gear ratio as well.

Here is another chart.

Well that kinda sucks. The front is pretty reasonably priced. The rear is the one that's out of control lol. I was telling myself not to get them as well. Then I saw 20% off and figured it was a sign from above to do it.

I at least saved you $500.

Without even trying on my way home from dinner. Stock no Baxter adapter yet.

I am installing mine tomorrow. Been waiting for oil change due. I'll let you know what I find out.

Adams drive shafts front and rear. Northridge has them 20% off $500 saving for front and rear.

No problem, Good thing Apex has great customer service as well.

Pretty good day, gave the guys a extra day off this week. I got to play in the shop with no one around to bug me. Been trying to find time to fab up bumper end caps from when I chopped my bumper. Installed apex flip kit, finally installed my new exhaust after breaking 2 mounts and bending the...

42-¼in and I am a rubicon as well.

1/2in showing each side.

I will be under my rig tomorrow, I'll measure and let you know. I'll be installing my flip kit from apex.

20% off adams shafts. $500 savings front and rear, don't mind if I do!

Mine is bent slightly..... I have the rock jock in my shop installing next week.

Start with a basic check list on any off road site. Add to it later find what you like and what works for you.

Coming from metal work back ground I'll stick to steel. Especially for the cost difference.

Yep I cut a hole In the floor vs the firewall. I am sheet metal by trade so I wasn't nervous just mad lmao.