Search results

3.6L

I saw this, it’s a post about idle speed being too low. What I’m looking for is information about two different warm idle speeds.

After a cold start, I always wait until the engine RPM drop before beginning to drive. In warmer weather, the low idle speed was always 600 RPM. I’ve noticed as the weather has gotten colder the engine now wants to idle at 900 RPM. It seems like I would have to wait a long time for the 900...

Could you make the argument that changing the oil too soon means the break-in hasn’t been completed, and additional contaminants will make their way into the fresh oil?

I should have added… first vehicle I’ve owned with an oil life monitor and no mileage based oil change intervals in the owner’s manual.

I actually did see a post on here that mentioned factory oil can have additives to assist with breaking in a new engine. I didn’t investigate that claim any further, but I also hadn’t considered that break-in oil was even a possibility, and that possibility took away some of the urgency to get...

Just had first oil change completed after 4,000 miles (6,500 km). Note this was the first oil change since the factory fill. I sent in a sample to get an analysis done, and all results came back normal except for silicone, which was 114 ppm and the limit/base is >30. The lab believes the high...

Does anyone know exactly how the engine oil change indicator system works? How does it determine the percentage of remaining oil life, and when the engine oil needs to be changed. The post below mentions 350 hours of engine runtime, but I was told it’s calculated based on ignition key cycles?

Mine disappeared yesterday for the first time, and your instructions fixed it right away. This was an incredibly helpful post for a feature I use every day, thank you!

Thanks for the photo, has this message ever reappeared since you had the recall work completed?

What does the clutch slippage message say, and does it only appear when towing? I have not seen that one before.

Thanks for the photos. Did you have to fish the drain tubes through these areas, or they routed themselves when inserted from the bed?

I haven’t been able to locate the end of the drain tubes, do they exit inside the fender wells?

Apparently? I saw this comment in another thread:

The Gladiator’s bed has two drain holes located beside the front tie-down anchors, shown attached. (B) is covered by a plug, and exits into the gap between the cab and the bed. Does anyone know the path for drain hole (A)? Installation instructions for the Mopar Hard Tri-Fold Tonneau Cover...

Any updates? Interested to know if you experienced this issue with your tonneau cover. Quadratec has first and second generation installation instructions on their site, both have the same tailgate seal where the first two fins engage with the tailgate. First generation see section 4.5, and...

Were you able to factory order one? Also does anyone know what date the 2024 order banks officially closed?

Thank you for confirming, are any other parts required to install this insert? I have the non-locking version, and would like to swap it with this locking one.

Hi Benny, if I’m understanding this correctly, 7HR05RXFAA is the new 2024 grille insert with the cutout for the Mopar hood lock? I’m trying to decide if I should order this insert to see if works with the hood lock from BOLT.

Any updates? Does the 7HR05RXFAA grille insert have the lock cutout?