Search results

Hello all, Just had new wheels installed on my 2023 Mojave. I got 17x9s because when these 33s ware out I will put on 35x12.5s. The wheels have a 1mm offset with 5" backspacing. They fit the 33s fine and really look good. My only concern is I have about 1.8 inches of "polk" on both the front...

I will be opening up part of my dash to install Lasfit Aux switches. Will that make access for the Tazer any easier? Thank you, Varooom

No dealership. I was driving it last night and decided to try the fogs. Sure enough, they came on! When I got home I tested it. Works fine! Thanks guys. Varooom

Update: Silly me. Ignition must be in "run" for the fog lights to come on. The parking and all other lights will come on without the ignition being in run, but the fog lights will not. Does not mention that in the owners manual.

Hello all, Have been enjoying my 23 Mojave for about 3 months now (first Jeep). Recently installed a front bumper and winch. Looking to put some additional front facing lighting. My bumper has provisions to mount two lights on it. My question is about cooling as I live in Florida. If I put...

Got the fuel pump replaced under warranty yesterday. So far so good. Varooom

Puller worked. Thanks guys!!!! Varooom

Hello all, Planning on installing 4;88 gears in my 2023 Mojave with 37 inch tires (adding a 2" lift). Looking at the gear/tire charts this combo is very close to the 4:10/33 inch I am running now. My question is will I need to adjust the speedo and trans shifting? I really do not want to run a...

I don,t plan on driving around with the windshield down, just cleaning and maintenance. I know about the cap and the nut, no problem. Just cannot remove the arm. I have a tie rod puller that I think might work. Seems like overkill but that thing is really stuck on there. Thanks for the...

Hello All, Will be replacing my dash speakers and also want to do some general cleaning on my 2023 Gladiator. Tried to remove the wipers so I can drop the windshield, no go. Do I need a special puller? Is there a trick to this? Thank you for your time, Varooom

yes, the bed light switch works and the display on the dash works.

Very cool, thank you!!!

Update: No voltage to the lights themselves. Also, I do not get the indicator light on the dash. No power at the connection behind the bumper either. I am going behind the switch on the dash next. Will have to wait until tomorrow, kids are here for Father's day. Time to fire up the grill and...

Shall do! Thank you.

Yes, this is the original harness and bulbs swapped out of the stock bumper. Yes, passenger side for the plug in harness. Silly me, I should have tested the fog lights before the swap. Maby they were not working originally.

Thanks Sandevino, I will get under there with a multimeter and check voltage as you suggested. However, I have not found the fuse for the fog lights. Looked on the listing in the owners manual and nothing. It may be piggybacking on another circuit but everything else works. Thanks again, Varooom

So I put on the Jeep Adventure HD steal bumper this weekend. All went well, everything fit perfectly including the fog light swap with harness. Now the fog lights do not work. My bad, this is a new Jeep (about a month now and 1050 miles). I never tested the fog lights so I don't know if they...

Installed a "Jeep" Adventure HD front bumper and Badlands 12000 winch from Harbor Freight. I think it turned out nice. I was worried that the extra weight woulld cause the front end to sag a little but it looks fine. There is a 30lb difference in weight between the stock bumper and the Jeep...

Its the Jeep Adventure HD bumper I got from Extreme Terrain.

Thank you!!!