Search results

Bought a PPE transmission pan a couple months ago and installed it just before my surgery. I don't have any photos of my Gladly on this tablet.

There are a lot of valid points being made. But would I shell out $2500 for them? Nah, maybe I just miss the good old days! :LOL:

I grew up with locking hubs, as well.as the air operated disconnects failing in the 90's as well as many, many posts of fad's failing . My fad works fine but I actually prefer the piece of mind of a manual.

A lot in here have been asking about this.... I'm going to check on this!

I've run KO2's on several of my rigs. And what little snow/ice we get in Tennessee, the KO'2s never let me down.

If you have the drop carrier bracket in the rear you should be good.. As for the front, you will need to have the caster set right, can't remember the angle of the top of my head (darn pain meds) but I believe you need the pinion angle somewhere between 5-7 Degrees. I have mine at 6. Degrees and...

Did you by chance lower your driveshaft? I had the same lift and similar vibration, a 1" DS Carrier bearing drop bracket solved the problem.

I never had issues with spillage in my cup holders, And what little may spill are never a problem to clean.

this! Mopar Bed Outlet Kit 115 Volt - BEDOUTLETKITJT20 | Mopar Online Parts

@WILDHOBO I would appreciate it

Found these, just need to find the size if the pin that will be replaced! Quick-Release Pins - Grainger Industrial Supply

My daughter received her notice for her 2024 4xe, but they do not have a resolve for it as of yet.

I added a front camera. I'm also considering adding side cameras well

I used a industrial hair dryer (heat gun), plastic Razer, and goo gone! Worked pretty good for me.

I have been in many pursuits, but never pitted anyone. There is definitely more to this story seeing as the Officer mentioned a firearm in the vehicle. Stay safe everyone and buckle up!

Welcome, great color!

Same here, I had to drop mine for added clearance.

No, don't do this.. I did it a couple of years ago to my cows at the start of deer season, when I awoke the next morning....... My John Deer was shot to $hit!!!

I haven't had a problem with this, but I second a couple small pieces of Velcro on each side. I can't put a cover over mine because it sits inside the metal bumper and is a tight fit.

So.. I am currently saving for a no thrills 5.7 swap. Keeping my tranny and just a simple swap. Should I expect any hiccups in the process..?