I just dropped mine off this morning and the Service Advisor told me that depending on how bad the corrosion is will dictate the repair. If the corrosion is under the paint sealer than they have to order a new hood, if it is not under the paint sealer than it goes to the body shop for them to...
Getting back this after running it like this for a few days I don't like the current setup. At the time I figured it wouldn't be an issue having it on all the time but after a few days of driving it the Starlink takes a few minutes to boot up and connect and sometimes I have short trips and I am...
Nice upgrades. The RCV Axles have a limited lifetime warranty up to 43inch tires. Not sure about the Yukon's as I couldn't find anything on them. The local shop here runs the Dana 44 with RCV axles and 40-42 inches on all their builds with no issues.
Mine has been shorted and dumps out before the rear diff. This the only pic I currently have right now but can get better ones later if any wants to see it.
Just as an FYI I have an EcoDiesel so not sure if the fuse boxes are different. I have the red going to F96 Power Mirror SW and Yellow going to F102 Dual USB port. I used this test light to find the Fuses to use. Before I had it hard wired I was using the usb power adapter and it would not keep...
Here you go. You want to look at page 8. Then it will also depend on the dealership you take it to. I have found some dealerships make it harder than others on warranty repairs.
I have the Rebel Off-Road Xplor Full Height Bed Rack. I like it and it works great and they have a ton of accessories for it. I did come across this one from Xtrusion that looks pretty interesting that makes accessing the bed and the equipment mounted on the inside way easier.
JT XPLOR Bed Rack...
My clock stays on time. Initially I had the Red and Yellow wires reversed since I didn't read the instructions and thought the red wire was constant and yellow was the ACC but it is actually reversed and the yellow wire is the constant and the red wire is the ACC. After I switched them I didn't...
I use the Wolfbox Tripro 900. So far I like it but it is a little large for the JT so it does interfere with the sun visor so if you use them it could be a pain. It also works on a loop system so it records for 30 seconds, 2 min or 3 min depending on how you have it setup and then starts over...
Who cares what other people think. It's your Jeep. If you like it do it. If you are unsure you will like it just go with some cheap stickers first and then if you do like it replace the cheap ones with nicer ones. I have worked with @Underground Graphics before and they did a mock up for me so I...
Since this popped up I use an inline USB switch to turn it off. Also helps since sometimes it will glitch out and I can easily turn it off and back on while driving with the flip of a switch.
USB On Off Switch
That shouldn't be a problem. When I did the install I just connected mine to the constant power wire instead of one of the AUX wires. For the install you use a cigarette 12v connector anyways so you would just plug the starlink power adapter into that instead and I don't see why it wouldn't...
Yeah, the only issue is the brackets for it do not line up with the holes on the molle panel so I have to make a different mounting plate for it. The company that makes the mounting bracket also makes a molle panel but theirs was like $300 I think so I went with Amazon's for $89 with free...
yeah, it works just fine with the tops on. This screenshot is with the tops on. I have the plan suspended currently since I am not using it so it is showing a low speed plan.
I noticed you are from Lompoc. I grew up just north of you in Arroyo Grande and actually work remote from TX but my job is in SLO. To answer you question I purchased the Starlink Mini Car Adapter with it and then ran that down the passenger side A-Pillar and then behind the dash down to the...
Here is my setup but take it with a grain of salt as I am still getting in the overlanding and have only gone a few times. I have the Gen 2 deck system with a RTT. I can say that the mattress in my RTT was extremely comfortable and I using have issues sleeping since I have a quadruple neck...
I think it depends on what you want to do. I originally had the two drawer system and then wanted to go a different direction and removed it and sold it and added molle panels instead and a different way to mount my spare tire. When I got everything done with the system and took it out...
I am not upset and I have actually had issues. But you stated that you can set your watch by when the emissions will fail. I am just curious on when that is. You stated it but you can't seem to back it up.
I agree with both of you. An RTT is not for everyone and doesn't work for all...