Search results

But would it be a permanent write to the Jeep or a temp one like the Taser? If my understanding is correct, using JSCAN makes the write permanent. If enabled via taser it would disable and reenable by the marry unmarry process? Is that correct?

So after reading through the whole thread, it seems everyone is using the TAZER, did anyone enable the Bed Outlet via JSCAN?

I realize this thread is a tad old, but I was trying to find it the other day and ended up pulling mine, here is the part number if anyone else is looking for it... 68373899AA

Anyone run a wire such as 1AWG or 2AWG direct to a Bus Bar type setup in the bed for powering compressors, inverters and other electronic stuff from the bed? I have an ALUCAB canopy so it will be enclosed. I am thinking about using a Lynx Power In bus bar, modified to hold fuses. It is a bit...

Does anyone know if the Metalcloak Inner Fenders will work with the Grimm Offroad Dual ARB Compressor mount? Since the Grimm Mount is under the brake booster, I am wondering if it will interfere with the Metalcloak Inner Fenders? Anyone running this setup? Pictures would be great if anyone is...

Silly question but I didn't see it anywhere in this thread... when charging with an external charger does the speaker have any light indications? I purchased an external charger that should work (Volts and AMPS) but get no indications when it's plugged in. The charger indicated in the TSB is no...

Awesome, thanks.

When do you expect to list these on your website for orders?

For the length of the cross bars is it the 1250mm or 1450mm?

What size load bars are you using for the top of the cap? Also what size riser did you go with? Thanks.

I sold it recently. Thanks for asking though.

For Sale - 2020 Soft Roll Up Cover. No rips, tears or discoloration, decided I am not going to use it, placing a cross body tool box in the bed instead. $250.00 Hampton Roads / Virginia Beach Area for delivery or pickup

Did you receive this yet? If so is it the same material as the 82215617 cover? Pics would also help if you have some handy. Thanks.

I am using the Grimm Offroad Winch Pate, I have already uninstalled the winch plate, so more pictures isn't an option right now. I did try putting a bolt in there but it still shifted and locked the bolt in place, so I had to loosen then side bolt to get the hole to open up to release the bolt...

Did you have any problems with the inner frame support? Each time I tightened the upper bolt down the inner frame support would block the bumper bolt hole. Attached photo shows what I am talking about. For some reason the photo is rotated but the hole that is blocked is the passenger side lower...

So how is the ARB compressor holding up in that location? Any issues with water/mud/snow and operating the compressor? I am leaning towards this type install but looking for real world experience/issues/opinions. Thanks.

Placing this here in the Genral Topics section for more visibility... Purchased a new 21 JTR and the dealer had a Spireon/Kahu unit installed. They would not remove it nor would they remove the cost from the deal. The "service" that is included with the unit is 84 months per the dealer. No...

Do you happen to have the part number for the skid plate? I have all the needed parts, just looking for the actual skid plate. Thanks.

I may have missed it somewhere, but does anyone happen to have the part number for the actual skid plate itself? I am looking for just the skid plate, I have the brackets, nutserts and bolts, just missing the actual skid plate for the non-steel bumper. Thanks.

Has anyone confirmed F91 (Always Hot) and F52 (Ignition Hot) work for hardwiring a Dash Cam?