Sponsored

Search results

  1. A NOT lift post!

    Well there are either of these: SumoSprings Timbren SES And / or fancy shocks: TeraFlex Falcon I have the Timbrens on our JTR due to the trailer I tow.
  2. Large wire crimpers

    In addition to BatteryCablesUSA, these are also sources for custom made battery cables: https://custombatterycables.com/battery-cable-accessories/ https://gregsmarinewiresupply.com/store/ I bought this crimper to do the wiring for my winch and manual disconnect: TEMCO TH0006
  3. Joined the code P030x damaged camshaft club

    And then three months later... Have just less than 22k miles on the truck, have gotten the oil changes done at about 7k mile intervals.
  4. Joined the code P030x damaged camshaft club

    Had owned our 2022 JTR 3.6 for one day short of a year last week Thursday when check engine light came on and engine started running rough. Right at 20.5k miles. Got service appointment for this past Wednesday, dropped it off at 7:00 a.m., they had it back to us by 3:00 p.m. Thursday. Has...
  5. On Today’s Episode of “What’s wrong with this picture?”

    No front driveshaft? I wonder if they removed it on purpose so that they could get the "sway shocks" to fit?
  6. Sorry can’t find thread but any side steps go with Rubi Rails?

    https://archetyperacing.com/products/jeep-wrangler-jl-x-gladiator-stirrup?variant=43696964600021
  7. Armorlite regrets?

    I installed the Innovative AT Products kit, but I did what the Kraken install instructions say for de-pinning the connector and then feeding the wires through a hole made in the under the seat drain plug. The wiring for the compressor doesn't get routed through the drain plug in the passenger...
  8. Gladiator Glamour Shots

    Four days ago at the end of the Chicken Corners trail in Moab.
  9. Looking for higher capacity springs for my Rubicon but….

    Are you carrying the 600 lbs all of the time, or is that when you're loaded up? I installed these on our Rubicon: Timbren SES Rear To handle the weight of our trailer since it is a little tongue heavy compared to the trailer weight itself. Dry weight 2600 lbs, dry tongue weight 350 lbs. They...
  10. Arb Dual Air Purple wire with Auxbeam switch install

    The purple wire also powers the cooling fan. No idea how much current the fan draws as compared to the two relays.
  11. Bed Liner in Bolt Holes

    Using one of the tailgate bolts worked well for me today when I cleaned the bedliner out of the bolt holes. I also used the M6-1.0mm thread chaser from this set: https://www.summitracing.com/parts/sum-900198 since I had ordered it the day before NvrGvUp posted this tip. Ended up alternating...
  12. Zeon synthetic rope install tip

    The install of the synthetic winch rope onto the drum of a Warn Zeon winch will be much, much easier if you make the "tunnel" in the winch drum that the winch rope passes through as smooth as possible. I wasted four hours yesterday afternoon trying to get the puck in the loop pulled far enough...
  13. OE steel bumper - not flat where fairlead mounts?

    I installed the winch mount plate yesterday. I was surprised that the OE steel bumper isn't flat where the fairlead mounts: Is this normal? The supplied bolts were much too short so haven't mounted the fairlead yet. I wouldn't expect that torquing the fairlead bolts to cause that section of...
  14. Timbren SES requires spring removal

    The build date on our gladiator is 8-22 and it has the welded plate same as the OP has. Was able to install the SES today. Due to the tack welds they used on the nut to attach it to that top plate, there is only the one set of flats on the nut that can get an open ended wrench on. Went way...
  15. Armorlite regrets?

    I regret not knowing the following before doing the install last week: 1.) For the under seat ducts in both the factory carpet and the Armorlite flooring there are oval holes with relief cuts at the round ends of the ovals to allow the ducts to pass through. On my front passenger side Armorlite...
  16. Fairlead thickness?

    Warn winch got delivered yesterday. The included shiny aluminum fairlead is 1.25" thick. Want to get a black fairlead instead. A couple of options are available in both 1" and 1.5" thickness. Have the OE steel bumper, will be using the mopar winch plate. My initial inclination would be to get...
  17. Winch disconnect switch?

    Manual disconnect switches: https://www.waytekwire.com/item/44056/Cole-Hersee-880062-Terra-SR-Series-300A/ https://www.bluesea.com/products/category/11/Manual_Battery_Switches...
  18. Finding a Selec-Trac In Stock?

    The full time is listed under options and on the window sticker: https://www.ourismancdjalexandria.com/api/vhcliaa/inventory/15397/window-sticker?sv=MQBDADYASgBKAFQAQgBHADYATgBMADEANAAwADcAMgA2AA%3d%3d&make=Jeep&dealerCode=41838
  19. Finding a Selec-Trac In Stock?

    A Google search for: new jeep gladiator for sale "4:1 Rock-Trac HD Full Time 4WD System" near Virginia Turns up at least a couple of listings: https://www.ourismancdjalexandria.com/new-Alexandria-2022-Jeep-Gladiator-RUBICON+4X4-1C6JJTBG6NL140726...
  20. winch wiring - going big(ger)?

    Understand that using a snatch block is preferred due to lower load on winch. Still have the ARB one that I had for my Toyota PU. I've learned that the "ampacity" (ampere capacity) of cables is a function of the insulation / jacket. Higher temperature ratings of the jacket let the same AWG gauge...


Top