Search results

If 2025 is similar to 2024, this video was well done: . I had to replace my aux battery and this video was very helpful. Very detailed.

Thanks again for the help. Fixed the wire this morning!!

Thanks for the suggestion and the pic of the connector. That helps.

Thank you!!

Thank you. I wasn’t able to get both hands in that tight spot but can try a stubby screwdriver and see if that works. Thank you.

A rodent chewed through the wire (Mopar part 68598134AC) the runs along the top of transfer case. I tried to remove the plug at the end of the wire so I could repair the wire but can’t figure out how to remove the plug. Anyone have any ideas on how to remove the plug and if there is any special...

Did this a few months ago on my 24 Rubicon. It was tucked way in the back of the speaker, toward to the top. A long needle nose plier helped grab it.

Door handles on the back doors and tailgate that unlock the doors like the handles on the front doors.

I added the 1.5" teraflex spacer. I eventually added spacers in the back since the gap between the tires and fenders looked weird. I didn't add anything else to the suspension. I did have to adjust the steering wheel. It was a simple adjustment but be prepared for your steering wheel to be off...

It’s pricey but a nice, solid system. I haul my dog back there for long drives. It’s much better than the seats. I do have to lift him up and down though and wish I had gone with the lower platform. If you get both sides, expect to put them and then out a few times while you align them to perfect.

I have the taller one. Just took a pic of that area.

I have 24 Gladiaotr and it’s a perfect fit around the drink holders. I’m not sure about the yeti tumbler but the deck does not cover the drink holders. And yes, you can leave the jack in place. The deck will not interfere with the jack.

American Adventure Labs makes a bracket for the switch that goes in the engine compartment. It goes right where you pulled the wire out from under the airbox.

UPDATE: I finally received the Grimm Mounting Plate. Install was very straightforward. The wires do not touch the grill. The clutch handle turns without touching the bumper. Tips for others: Push the winch back and torque the mounting bolts before putting the bumper back on since the front bolts...

I have the same set up and you should have everything. Install was straight forward. The instructions on the Grimm website were great. I didn’t put the skid plate back on but watching videos of others, it’s recommended that you put the bolts on and leave them loose so you have some play in the...

Correct. This kit is just the wire connector. It worked with an existing tender I purchased from Costco without any modifications.

I added a charge safe magnetic trickle charger. You can drive off without worrying about disconnecting it. It also fit perfectly with the grill.

I ordered the Grimm plate in Dec. Still waiting although I think they are shipping soon!

Nice!! Thanks for the report! I couldn't find anything online about what bolt to get so it's good to know the necessary hardware is there. And thanks for the tip about torquing.

Thanks for the all the responses. I ended up ordering a Grimm mounting plate. I'll report back in case this helps someone else decide which plate to use.