Search results

Yes, I would stay with the Pennzoil Platinum Euro 5W-40 and just change the oil every 5,000 to 7,000 miles - at this time AMSOIL does not have any oil that meets the MS-12991 requirement

I read through a lot of this thread. I then called AMSOIL - as I was ready to switch from Pennzoil Platinum Euro 5W-40 to AMSOIL European Formula FS 5W-40. Here are the facts - just facts don't shoot the messenger :) Through my discussion with AMSOIL - AMSOIL confirmed that they do not...

This is from another post I did on the same topic ... On my 2022 Rubicon Diesel with an aluminum front bumper and a 16.5 lb Waren winch with metal cable – so I have a “heavy” front end…, I installed the Metalcloak Springs #7609, Lower control arms 7601 and the 5100 Bilstein Shocks (shocks on...

On my 2022 Rubicon Diesel with an aluminum front bumper and a 16.5 lb Waren winch with metal cable – so I have a “heavy” front end…, I installed the Metalcloak Springs #7609, Lower control arms 7601 and the 5100 Bilstein Shocks (shocks on front #33-305219 & rear #33-304854), the Bilstein...

Thanks to everyone ..... I went back to the front end alignment shop as I saw one of the lower control arma was 1/2 a tun off when they adjusted the alignment. I had them adjust the lower control arm so they were equal, I then had them loosen all of the lower control Arm bolts, put the Jeep...

There was no way I could get the Metalclocloak spring in ... my stock Gladiator Rubicon springs were about 18 inches, they came out ok, but the Metalcloak were 21 3/4 inches - I had the Gladiator up on cack stands - tire was about 3" off ground when I removed it - then had axel down so brake...

Thank you for your comments - I looked everything over and installed my sway bar links. I found that when I got my alignment they adjusted one control arm a half turn more than the other control arm - which created 2 issues - One issue is one arm was slightly longer than the other, second the...

I just installed the Metalcloak springs #7609 21 3/4" long - I bought the Harbor freight spring compressor for $37 - it was very easy to use. I compressed the new springs down to 17" and slid them right in no problem & very quick just seat the springs properly, top & bottom, before raising...

Help Please... 2022 Gladiator Rubicon Diesel with 33" tires. Well, I installed the Metalcloak Springs #7609, Lower control arms 7601 and the 5100 Bilstein Shocks (shocks on front & rear). Springs & lower Control Arms only on front = the result is a 2.5" lift that basically leveled the...

I have a 2022 Gladiator Rubicon Diesel with 33" Wildpeak AT, a rock Hard aluminum front bumper and a warn 16.5 winch with wire cable. So overall I probably added 130 ish pounds with the bumper & winch. My issues are; when I hit certain road bumps the front "bottoms out" with a pretty good "bang"...

this just happened to me last week. Same issue the actuator went out and they have to replace the whole turbo. I was shocked when they told me they have to remove m cab... Mine is still under warranty, lucky as they told me this is a $12k job. They also said that after they replace the turbo...