Sold: Virginia Amp Research Powerstep XL

[xrecar]

UPDATE - These are taking up space and getting in my way. I want them gone so I have space to store my hard top. Dropping the price to $300!! Also, I spoke with Amp Research and they verified that the tabs that are broken are not structural. They are only there to help align the boards during install. You can pickup the new module for $90 and you’d have a nice $2000 set of steps for a steal. Come and get them!

Asking $500 OBO. Retail price for these new is $2100. I bought these used and they were supposed to be in excellent condition. I installed them and ran into a couple things so and I’ve decided to sell them. I want to be completely up front about the condition of the steps. I don't consider them to be in excellent condition, but I would say they are in good condition. They have some chips here and there. Also, the module that interfaces between the door circuits and the steps is not working for the rear passenger door. A replacement module can be had for about $90. I can provide the buyer with the model number and website where you can buy the part. The other issue is that on each of the hinges there are tabs that are broken off. I have included a couple photos of examples of the hinges so you can see what I mean. I cannot say if those tabs are critical or not. They may just help to align the board where it mounts. I did have the steps installed and working on my Gladiator (as seen in the photo below) and I also have videos I can send to anyone interested in them.

I am not interested in shipping at this time due to the pain and likely high cost with shipping.

Let me know if you have any questions!

Thanks,
Rob

Sponsored

 

[xrecar]

Bump for updated price and info.

 

[KoBear]

How far from Koons are you?

 

[xrecar]

@KoBear - You’re talking the Jeep Dealer @ Tysons Corner I’m guessing. If so it’s about 3 hours, 20 minutes. I’m basically n the north side of Roanoke, VA

 

[Monkey6]

I will take them if you can hold them for about a month. I'm 4 hours away, but will be traveling through your area on the 16th next month.

 

[93NASDefender110]

Really interested. But I will need it shipped to Miami, Fl.

 

[xrecar]

I appreciate the interest, but I could have sold them for considerably more if I wanted to deal with shipping. As I mentioned, I’m not interested in trying to ship them. These things are just over 7 ft long and I don’t have boxes for them. Plus with the weight of the motor/hinge assemblies, the cost would be prohibitive.

 

[xrecar]

I will take them if you can hold them for about a month. I'm 4 hours away, but will be traveling through your area on the 16th next month.

I’ll keep you in mind, I need them out of my storage building asap. So far I’ve not had any local (or nearby) interest, it’s all been people wanting me to ship them so they very well may still be here then!

 

[F1REICE]

Pm sent

Sponsored