Interior trim panels removal

[AggieJeep]

Does anyone have a resource for diagrams / procedures regarding interior trim panel removal / installation? The panel by the rear seat door latch popped loose while I was routing a wire and I can’t snap it back. I have always had bad luck with auto trim. I‘ve searched high and low but haven’t found a service manual for the JT or a how-to on this panel. Been tinkering with this for several days when I get a little time, extremely frustrating. I’m sure it is simple once one can see how they are fastened. Until then, I’m back to finding the cure for the common cold

Any pointers appreciated

Sponsored

 

[ChadM]

better late than never I was just coming here for the same reason... The armorlite install vid does a pretty good job showing how to remove and reinstall the inside door trim along the floor. I need to route some wires under it wanted to remove it to properly secure everything.