LED Tail Light resistor wiring

[firejim]

I recently upgraded all my halogen lights to Oracle Lighting LED’s. I am replacing my rear blinker/taillight bulbs. I need to install a load equalizer on the ground and blinker hot wires. I have four wires to choose from, Black, White, Grey and Yellow. I am assuming Black is ground, but not sure on the others. I tried a meter and for a bit, yellow looked like it might be the blinker hot. Can anyone confirm? Thanks

Sponsored

 

[ORACLElights]

Hi Jim, the black is ground and yellow is blinker(+). Our install guide video might be helpful or you can always call us for install help.

 

[firejim]

Got it thanks.

 

[Swaggy_T]

Got it thanks.

Did you get this figured out I put in the resistor on the black and yellow wire and it didn’t work

 

[Ammo]

I used the black and yellow wires, and it worked. It worked on one side but not the other but I turned the bulb around and then both sides worked as intended.

 

[Pmbrown9]

Hoping for some help. Do you know where to get these resistors? I am upgrading to the stock LED Tail Lights on my Jeep and am trying to avoid the dealer flashing the computer. The dealer mentioned resistors should work fine. They can only flash the computer for all lights to be LED and if they do that my front fender lights won't work.

Sponsored