Poison spyder crawler bumper fog lights

[MTDIRK]

wasn’t sure where to post this, probably more of an light question. So went to install the new bumper and winch today and bumper comes with options for 3 different fog lights. Unfortunately none of them work with the Rubicon plastic bumper with LED fogs that I have. Anyone know if the 4” Rigid 360 will mount in the bumper? Second choice is the diode dynamics.

i emailed both companies today but hoping to get something ordered this weekend.

Sponsored

 

[DeezJT]

Did u figure it out? I just purchased an open box PS Crawler but comes with no hardware. I'm thinking the hardware is just the fog light brackets? I plan on putting my JWS Fogs.

 

[MTDIRK]

Poison Spyder said to just drill new holes in the mounting plate. I haven’t gone out to see if I can get my drill in there. Would prefer to have a direct bolt in solution and not have to pull apart every year to make sure there is no rust.

hardware would be mounting brackets for sport fog light or JK fog light conversion. Also included washers and grade 8 nylon nuts.

 

[kickingaz]

Poison Spyder said to just drill new holes in the mounting plate. I haven’t gone out to see if I can get my drill in there. Would prefer to have a direct bolt in solution and not have to pull apart every year to make sure there is no rust.

hardware would be mounting brackets for sport fog light or JK fog light conversion. Also included washers and grade 8 nylon nuts.

I have a Crawler Conceptz bumper on my Gladiator which is very similar to the Poison Spyder bumper and I drilled 4 holes in each side to mount the factory LED fog lights. It is very simple assuming you haven't installed the bumper yet.

Sponsored