Removing LED DRL

[RPgladiator]

New here. And new to jeep coming from toyota tundras. I recently took ownership of a 2020 gladiator and i purchased go recon led drl to replace the led stock drl turn signals. Is there a write up or any info on how to remove the stock light and does the entire fender need to come off to install a drop in light.

Sponsored

 

[UseThe4orce]

Im also looking into pulling out my drl to tint them. Will look in the AM but im guessing you just pull the inner fender plastic trim off and gain access to whatever hardware is holding them in.

 

[RPgladiator]

Im also looking into pulling out my drl to tint them. Will look in the AM but im guessing you just pull the inner fender plastic trim off and gain access to whatever hardware is holding them in.

Yeah not to sure. I just had the shop put it in while doing my lift

 

[BigRed97]

You could probably do it with the fender on the car but the whole thing pops off in about 2 minutes, couple bolts and trim clips then pop the fender off and unplug the harness at the body

And it's much easier with the fender off and laid on a table

Sponsored