Search results

I bought this one from Cross Country Teardrops in NC, I dont think they are building campers currently. They let me draw them up in cad and they build it how you want it.

5x9 Squarish drop camper 1800 lbs loaded up

how much for the rear 3/4" spacers shipped to 29036?

I'll take the rear spacers.

You mean mtb? yes I ride out there a good bit.

the front flaps just mount through the inner fender plastic with screws that thread into the mudflap. The rears have very extensive brackets that are nice.

ripped off my front Rokblokz flap on the trail last week. It ripped the knobs off the bolts and the tabs out of my inner fender. I was able to mount it back, but just be careful when you get it offroad and up in the dirt. dirty side that ripped off: vs clean side that still had a flap:

teraflex 1.5 spacers in the front, no other changes to suspension. haven't taken any pics of it on flat ground yet.

I've done the GA traverse also, there are only a few places that are more difficult on the DBBB and there are route options that avoid the difficult trails. There are more water crossings on the DBBB and some of the trail is rutted pretty bad. Test the depth of any water/mud that looks...

stock...ish

just picked up my diesel JTR in August, I'm in Chapin/Columbia area

Our club rode the DBBB back in 2018, and there have been a number of changes to the trail since then with new land added and some trails removed from the route. Last time I went in my JKUR, and this time I took my Diesel Rubicon. This was a challenge in a bone stock truck, but we had a good...

anyone with grey still want to trade for red?

can you post a pic of your front bumpstop?

I would think a simple swap to the larger bumpstops would help significantly. I installed a teraflex leveling kit to help with the bottoming, it would bottom on pot holes and dips in the road before the leveling kit. Its better now, but when it bottoms its still very harsh because there is so...

Sold

So thats what my diesel came with also, but the original JT bumpstop looks like this: https://www.quadratec.com/p/mopar/front-axle-bump-stop-jl-jt-68251638AA?gclid=Cj0KCQjwwNWKBhDAARIsAJ8HkhdBkN2l5D-S1QV1qURpQXUzYyCVzKv5EhrmO0r8e84unsijj8x2k6EaAuRaEALw_wcB and this is what it shows in most...

I haven't read this whole thread I'll admit, but when I was installing my teraflex leveling kit on my JTRD I noticed that the factory bumpstops are super small and barely stick out of the front bump stop cups. This is totally different from whats shown in the install video for the teraflex kit...

Just took them off of my new 21 Rubicon $50 Located in Chapin, SC