Search results

could you let me know what this torque bit inside the wheel is called and or torque spec? Got new cotter pins

Back or Back ordered for almost 8 months via fox

I have 21 mojave stock height 35inch kendas Mostly not returning to center. upgrades stabalizer got alignment and such because I had to remove Synergy track bar for stabalizer install

How exactly to adjust caster?

Mine was a stone inside the dust shield. Anybody hearing this noise on theirs check dust shield just by brake rotar

At low speeds I have recently been hearing my Mojave make a squealing noise that I can’t quite pin points. figured I would post some videos in the even others have found a solution. Stock Mojave 35inch tires.

I found a thread with many other glad owners complaining about the same vibration I am referring to any many of these same owners are saying they too had axle/diffs replaced.. here is my contribution to may be happening with my sudbtle vibrationz I have also got my Mojave’s front diff and...

continued aggregation here as well. to contribute to this thread, like many of you stated with this subtle vibration, I have also got my Mojave’s front diff and axle replaced at 10k miles and that’s when this issue started. when I first bought mojave new off lot, I noticed whenever engaging...

I have heard nightmares from people with tinnitus. I landscape and do installs so I’m always wearing ear protection. Would it hurt to spray the drift shaft with fluid film and or any parts you mentioned with silicone spray? I bet that it’s the metal bracket that holds the brake tubes right by...

Maybe it’s the timing belt squealing

35k,heavy off roading 5 or 6 times I also loaded the bed up with about 1200 pounds for 30min haul, have air bags for daily towing in the summer at most 3k pounds includes trailer and whatever is loaded on it> just to give you the full background

I have had a vibrate and or tremble feel comming from the floorboard for 10k miles, I read these can put a band aid on underlying issues, and this it did. Drives like a Cadillac now, still need to check both joints or whatever that subtle floor board vibrating is from

Is there a way to properly adjust that only with out uninstalling

you can hear chirping in the background. High pitch clearly

I believe the way the brackets are set up, this is what the final looks like, unfortunately I couldn’t get the falcon decal sticker to face away from front of truck.. After install… I think it’s ass upside down in other words whatever setting is facing towards the rear is the setting I am...

Do we need to prime these or bleed them before installing? the falcon out of the box doesn’t flex at all too much compression

This looks to be the part number teraflex falcon said we needed- 6510774AA this looks like a flange nut

That looks more like a nut than a bolt

Stand by

This is the only vehicle I have owned where I don’t feel I need to floor it to enjoy it