Hate to bump this but I am having this issue. In cold starts idle is smooth till the temls gets around 145 and remained rough till it got to normal operating temps. No codes or check engine light on. If I give it Little gas and it smoothes out but when dropped to idle the rough idle will...
Hey all. After I got an oil change and some rrts done. I noticed right away vibration at idle along with an odd noise with the vibration. Last for a few seconds. I would have went back in but my local dealer is not very good. Im reluctant to even let em change my oil but jeep wave lol. Anyway...
Hey all. I bought these for a truck I monger own. Tried one bulk out to see how it looked, then sold the truck and these have been sitting. I purchased theses from headlight revolution. I was going to use them on my current truck but picked some factory leds headlights instead.
Asking 70 shipped
Ya I ran both pins down to the bcm connector. The pins didn't give me a satifying click but they didn't pull out so I thought I was good. Ill check power to headlight connector to see if power is going down. Lol I may remove the seat this time. Im not as slim as I used to be
Hey all, I've recently installed rubicon fenders with led turn signals. Installed mopars led headlights. Used a tazer mini for the lighting options. Everything is fine minus the driver side halo.
I've turned them on and off several times through the tazer as some have said this worked to turn...
The rubicon flare have led turns signals have a single plug for the circuit board and the max tow uses two plugs for the holden bulbs. I haven't counted the pins so I guess I could get a connector for the board. But ots not a straight swap over
Hello all. I Hve a max tow and im in the process of swapping the non led fenders for some rubicon led fenders. Unfortunately the fenders do not have the harness. The small turn signal connection is there but missing the main harness. Tried searching and I'm not getting much luck. Thank you in...
Hey all, I recently replaced the rear bumper on my max tow with a rubicon steel bumper and bed sliders. The rear bumper has the 4 slots for sensors which I don't have . I was looking at what options I had to utilize the holes. I was think led lights for back up lights or amber lights. Antenna...
I ordered one last sunday using the deal and got it Thursday and installed today. I dig it, though I think the front window needs some adjustment. I still need to apply either the front velcro or snaps and rear velcro. It does look a bit off to me especially in the back but I'll wait till its...