California 1/4" or 3/8" steel plate bumper spacers

[svc707]

I don’t have any 3/8 or 1/4 plates on hand but I’m cutting 3/16 plates and 1/8” plates til I get more material.

I’ve got 3/16” plates cut. Stack two plates to create 3/8” or run single for just under 1/4”.
I’ll be cutting 1/8” plates next, stack two 1/8” and you’ll have 1/4”.
Although I’m using more material this way and more consumables cutting I will still offer these at the same price of 3/8 or 1/4.

thank you again for the requests and patience ?

Steve

Sponsored

 

[svc707]

One more just to clarify ?

if you want 3/8” I’ll be sending total of four 3/16” plates. Stack two on each side will net you 3/8”

$45 shipped for the set.

 

[svc707]

I have a few more sets ready to ship

??

 

[svc707]

I cut another sheet today. I’ll start cleaning and packaging tomorrow

 

[svc707]

I think I have about 8 sets remaining from this batch then I need to do a materials run.

 

[svc707]

More plates cut ….

I updated first post. Using 1/8” plates to give end user ability to adjust as needed.

I still need to clean the plates but will start shipping out again in a couple days.

 

[Midlife_Gladiator]

Yes. I put after winch mount. Between winch plate and hook plate.

Hey there. I would like a set of 6. I run the arcus and the badlands and it doesn’t fit at all. The winch is smashed against the grill. The bumper is touching the edges of the winch.
I noticed you put the plates on the outside of the winch plate. If you put it on the inside of the winch plate would it give the winch a bit more clearance? I’ll buy a set of 6 right now.

 

[svc707]

Hey there. I would like a set of 6. I run the arcus and the badlands and it doesn’t fit at all. The winch is smashed against the grill. The bumper is touching the edges of the winch.
I noticed you put the plates on the outside of the winch plate. If you put it on the inside of the winch plate would it give the winch a bit more clearance? I’ll buy a set of 6 right now.

Yup you can spread around and don’t forget to move harness to exit side of cover

 

[svc707]

More plates getting cut …

 

[svc707]

Thank you for all the referrals to other members here. I have three sets of (6 plates) remaining from this batch I’ll try and cut more in the next couple weeks.

 

[jnett]

Thank you for all the referrals to other members here. I have three sets of (6 plates) remaining from this batch I’ll try and cut more in the next couple weeks.

What size plates are currently available and are the prices still the same as originally listed in the post?

 

[svc707]

What size plates are currently available and are the prices still the same as originally listed in the post?

Yes, same. As first post. Qty of 6; 1/8” plates , netting you 3/8” per side. $50 shipped

 

[svc707]

More plates cutting

 

[ColoradoCantu]

Hi Steve, I am needing 3/8", so 6 plates, if you have them ready to ship?

 

[svc707]

Hi Steve, I am needing 3/8", so 6 plates, if you have them ready to ship?

Yes, I have them ready to ship
I’ll send you PM

Sponsored