madduck
Well-Known Member
- Joined
- Oct 18, 2019
- Threads
- 13
- Messages
- 120
- Reaction score
- 64
- Location
- South Mtn., AZ
- Vehicle(s)
- '20 Gator JT, '77 SJ: Cherokee Chief, '06 LJ
- Occupation
- High Speed Al tubing manager
- Thread starter
- #1
i know it's on here somewhere...but i'm not finding exactly what i'm looking for...yet.
i'm mouting a ham antenna on the drivers side fender, i'll run the coax through the clutch hole in the firewall.
on the pax side i'm putting a CB antenna. here's the question:
i saw a thread where guys were using a coat hangar to push through some foam insulation on the firewall into the cab. where is that hole?
i'd prefer to use a shorter length of coax and stay on the pax side of the jeep when routing the cable to the CB. i can run it across the firewall
on the engine side, go through the clutch hole and then thread it through the dash back to the pax side to my CB. but i'd prefer not to.
thanks for any info/intel, the help is appreciated.
cheers, madduck
i'm mouting a ham antenna on the drivers side fender, i'll run the coax through the clutch hole in the firewall.
on the pax side i'm putting a CB antenna. here's the question:
i saw a thread where guys were using a coat hangar to push through some foam insulation on the firewall into the cab. where is that hole?
i'd prefer to use a shorter length of coax and stay on the pax side of the jeep when routing the cable to the CB. i can run it across the firewall
on the engine side, go through the clutch hole and then thread it through the dash back to the pax side to my CB. but i'd prefer not to.
thanks for any info/intel, the help is appreciated.
cheers, madduck
Sponsored
