Fog Lights Wiring?

[imallcrawl]

I tried to search for a tutorial on how to wire led fog lights into the factory fog light wiring but I couldn't find anything.

I have some cheap led fog lights that I will be mounting onto my bumper and being I won't be using the factory fog lights, I wanted to wire the new LEDs into the factory fog lights by using the same plugs so I can just use the fog light switch from inside the cabin. Does anyone know how to do this and if so, can you shoot over some instructions? If it helps, the wiring coming out of the leds are black, yellow and red.

Thank you very much!!

Sponsored

 

[imallcrawl]

I found this but I have no idea wth I'm looking at lol

 

[imallcrawl]

I think this should be good to assist with the wiring

https://www.jlwranglerforums.com/forum/threads/fog-light-wiring-connector.14104/

 

[wcberry]

I tried to search for a tutorial on how to wire led fog lights into the factory fog light wiring but I couldn't find anything.

I have some cheap led fog lights that I will be mounting onto my bumper and being I won't be using the factory fog lights, I wanted to wire the new LEDs into the factory fog lights by using the same plugs so I can just use the fog light switch from inside the cabin. Does anyone know how to do this and if so, can you shoot over some instructions? If it helps, the wiring coming out of the leds are black, yellow and red.

Thank you very much!!

I dont see this as being that hard. Just need to disconnect your current lights and splice in the LED lights once you figure out the wiring but if your old fogs are not LED, you may need to use JSCAN or Tazer to change the computer to LED or possibly add some resisters.

 

[imallcrawl]

I dont see this as being that hard. Just need to disconnect your current lights and splice in the LED lights once you figure out the wiring but if your old fogs are not LED, you may need to use JSCAN or Tazer to change the computer to LED or possibly add some resisters.

Got it thank you! I'm not an electrician but I've hooked up LEDs before, however I usually use the wiring harness it comes with and run a switch into the cabin. This is the first time I'm attempting to wire directly to the factory wiring.

Sponsored