LED front turn signals

[TDFRANKE]

Im looking for some help on a 2020 Gladiator put LED turn signals in and they work fine until you start it Then they go out. I've seen lots of goofey stuff in my time but im at a loss on this

Sponsored

 

[Kevin_D]

Did you replace the entire turn signal/DRL assembly, or just put LED lamps in the existing signals?
Do you have LED rear lights?

Kevin

 

[TDFRANKE]

Did you replace the entire turn signal/DRL assembly, or just put LED lamps in the existing signals?
Do you have LED rear lights?

Kevin

replaced the entire assembly with the harness to plug into factory harness

 

[texanjeeper]

You're a man of few words....what brand did you use, did they suggest resistors, or are they built in....these are just the basic questions, more will surely follow.

 

[Kevin_D]

replaced the entire assembly with the harness to plug into factory harness

Again, what about the rear lights?

Kevin

 

[TDFRANKE]

Here is what I have a 2020 gladiator LED's front and rear the rear signals work fine the only problem is with the fronts when it is running but work fine with koeo not sure who made the rears the fronts are Audexen LED's it was brought to me after they could'nt get them to work. it also has led side turn signal markers behind front tires They all came with harnesses to connect to factory harness without resistors but there are some mounted in the front I've tried with and without but no change This is my first time being on a forum i do appreciate the help you guys give me. I hope this is enough info to send me in the right direction

 

[mdyucca]

I put in Mopar LED turn signals converting from factory incandescent. In order for them to work properly they required going into the cars PCM and changing the turn signal type from incandescent to LED. I don't know if all Gladiators have the ability to change this setting. If your Glad can be changed this can be done by a dealer or with a programmer ie. Taser. If you are using aftermarket you need to determine if they are plug and play or if you will need to configure the lights to your wiring system with resistors/decoders. Without knowing exactly what you have it will be difficult to get you the information needed. Good luck with your LED's the information you need has most likely been posted somewhere on this Forum. It's just a matter of finding it.

 

[Kevin_D]

If your Glad can be changed this can be done by a dealer or with a programmer ie. Taser.

I don't see why it couldn't be changed...
You can change it with a Tazer, JScan, or AlfaOBD. The Tazer is expensive, but also does more than the other two. JScan can be acquired for about $60, if you shop carefully. You do need to buy a license for each vehicle you'll use JScan with. I have no experience with AlfaOBD.

Kevin

Sponsored