Looking for someone who has an X4s installed

[RealTruck]

I know I have SOLD many on here and I am needing some assistance!
I know I had this information at some point but seem to have lost it

Can one of you kind souls that have an X4s on the Gladiator PLEASE post a picture of the measurement from the center of the T-Slot to where the rubber seal of the cover is? @Blindjustice1787 and I would be extremely appreciative!


Just to be clear as an example I am needing the measurement of the red line

Sponsored

 

[Fcmalie]

If no one has gotten back to you by the time I go to lunch I can take the measurement. Could have sworn I had it already for when we were figuring out bed rackmounting brackets, but ?‍

 

[Bananaman]

 

[Bananaman]

Just a hair under 1 11/16"

 

[RealTruck]

If no one has gotten back to you by the time I go to lunch I can take the measurement. Could have sworn I had it already for when we were figuring out bed rackmounting brackets, but ?‍

I COULD HAVE SWORN I HAD IT TOO!

Looks like @Bananaman and @JohnQ (another post I made) got this information up now

You guys rock thankyou!

 

[RealTruck]

@Blindjustice1787

 

[Blindjustice1787]

Can you also take a measurement of the height of the cover when it is rolled up? I am looking at a rack that has a small, but present, inward angle, so I want to ensure the rack would not hit the support leg closest to the bed, if that makes any sense at all!

Thanks for the measurement and reply!

 

[Bananaman]

Sponsored