BruteForce
Well-Known Member
- First Name
- Jim
- Joined
- Sep 16, 2019
- Threads
- 21
- Messages
- 249
- Reaction score
- 315
- Location
- Utah
- Website
- utahbruteforce.com
- Vehicle(s)
- 2020 Jeep Gladiator, 2009 Ram 3500 CTD, 2001 Toyota 4Runner
- Occupation
- SVP/CISO
- Thread starter
- #1
Went to replace my bulb (passenger side turn signal) and it fell inside the housing. I've tried everything to get it out. I assume the only way now is to remove the entire assembly and shake the bulb out.
What I've tried:
-Pick-up claw tool (it just ended scratching the inside of the lense)
-Double sided tape on my finger and a screw driver
-Shop-Vac right up to the hole and me pounding on the housing
ARGH! Frustrating!
No YouTube HOW-TO video on removing that housing assembly and peeling back the fender liner, it wasn't super obvious on what I had to take out to remove. Feedback appreciated, otherwise its off to the stealership to have them address. I can see them charging me $250 to remove that stupid assembly just to retrieve my bulb.
What I've tried:
-Pick-up claw tool (it just ended scratching the inside of the lense)
-Double sided tape on my finger and a screw driver
-Shop-Vac right up to the hole and me pounding on the housing
ARGH! Frustrating!
No YouTube HOW-TO video on removing that housing assembly and peeling back the fender liner, it wasn't super obvious on what I had to take out to remove. Feedback appreciated, otherwise its off to the stealership to have them address. I can see them charging me $250 to remove that stupid assembly just to retrieve my bulb.
Sponsored
