Rough Country Tubular Bumper Install Help

[American Pinecone]

Just got the Rough Country Tubular Bumper today and started on the install. Has anyone else put this bumper on themselves? I'm having the hardest time figuring out how to install the light bar into the light bar slot. I would also like to know how I can wire the small box fog lights included in the kit to my factory fog light switch (I don't want to have to wire them to my aux switch).

Sponsored

 

[BlueTheJeep]

Better a year and a half late than never I guess, lol. The 2 inch cudes being wired to the factory switch is simple. Run the wire for the switch on the Rouch country wiring harness down with the leads for the lights to factory fog light plug on the passenger side front frame rail. Cut the end off the factory bumper fog light harness and wire it in place of the connector that Rough County harness came with. It's 3 wires black, white/yellow and white/blue, as long as you go black ( ground ) to black the other two are interchangeable. Bam Bob's your uncle!

I finished installing mine 45 minutes ago lol.

 

[BlueTheJeep]

Oh that light bar is a pain! Bolting them in on the sides with minimal access is ridiculous, to get it tight and keep it from shifting I used one of the rubber feet that it comes with for the "A frame " style mounts and wedged it on the passenger side of the light bar. Couple cuss words and some persuasion and it was in.

 

[AstroZombie]

pictures or it never happened!

Sponsored