Rough county spring look bent

[tocuyo]

Hi all, I recently installed a rough country leveling kit and I noticed the driver side spring looks bent.. is this normal, how can I fix it??

Sponsored

 

[Mouse]

That's not unusual. Longer, aftermarket springs do that sometimes. I'd make sure it's indexed in the rubber isolators correctly and watch to make sure the spring doesn't rub on anything.

 

[Mac]

There are a few threads about this, Daystar makes new lower isolators that correct the problem, they are around $30, I just ordered a set yesterday. They are listed for JLs not the JT.

 

[tocuyo]

Will look in to that! Thanks

 

[j.o.y.ride]

Make ceratin your isolators are properly aligned. The factory isolators are angled. If you get them back in at the wrong angle it will do this. From the pic it looks like the high side of the isolator on bottom is on the inside, causing the whole spring to shift outwards. Check it, and the upper, for proper position.

 

[tocuyo]

There are a few threads about this, Daystar makes new lower isolators that correct the problem, they are around $30, I just ordered a set yesterday. They are listed for JLs not the JT.

I just checked on their site and noticed there is two of them. One for mopar lift and the other for aftermarket lift. Not sure what’s the difference??

 

[Deleted member 30519]

I have the same kit. Mine looks a little bowed out but not as bad as yours.

Sponsored