Rubicon Locker Retrofit into Mojave

[OldButStillJeeping]

So, Basically I'm interested in putting a front locker into my Mojave and installing the factory Rubi dash switch plate. To facilitate the operation in 4Lo and 4Hi.
I know it's not brain surgery and ordering the right parts is the key.
Any Jeep employees want to share the part numbers and such?
On the down low, of course.

Sponsored

 

[Jaxmax]

Benny on the forum here moparparts.com, can find you any parts, can supply them at pretty good prices, but he will find you the numbers. Will be cheaper to find a member swapping out to Dana 60 axles and buy their used rubicon front axle.......Jack

 

[OldButStillJeeping]

Benny on the forum here moparparts.com, can find you any parts, can supply them at pretty good prices, but he will find you the numbers. Will be cheaper to find a member swapping out to Dana 60 axles and buy their used rubicon front axle.......Jack

Thank you!

I plan to go with an Eaton E Locker up front, and tie it into a factory Rubicon dash switch. As I'm quite content with my factory Dana 44 on my Mojave. I'll do the locker install as I've done a few... & have the tools... saving the labor $ to a diff shop.

Thanks for the info. Much appreciated!

 

[yoda13]

I will be watching this thread as well, as I don’t want to do away with the Mojave axle...

 

[andrew8404]

You can’t buy the elocker it’s not available. You can pretty much only do ARB lockers or air actuated ones. As the other member said swap is the best way to go.

 

[yoda13]

I will probably go the aftermarket route then...probably ARB, or OX. I don’t want to replace the Mojave axle.

Sponsored