Skid plates

[Sruss915]

Hey everyone! I've been doing some digging and was wondering if these skid plates would work on the gladiator? https://www.roughcountry.com/exteri...0-jeep-gladiator-jt-4wd-379105&sid=XTGhOPGJcG

Sponsored

 

[WhatExit?]

Hey everyone! I've been doing some digging and was wondering if these skid plates would work on the gladiator? https://www.roughcountry.com/exteri...0-jeep-gladiator-jt-4wd-379105&sid=XTGhOPGJcG

Link shows no products available...

 

[jurfie]

Only skid plates that I have seen for the JT so far are Artec, Rock Hard and Metalcloak. I'm sure more are on the way...(Genright, EVO, JCR, etc.).

 

[Sruss915]

The skid i was wondering about is from RC but its for thr JL. I was wondering if the JL and JT are similar enough that it would work?

 

[Sruss915]

https://www.roughcountry.com/jl-ski...nayQp6ICyclb0W-rStuvytbNhBl5ucW4aAnzOEALw_wcB

 

[highoctane]

I’m traveling for work and can’t load your link, but keep in mind the engine mounts are different in the JT. So if you are shopping for engine/auto xmsn skid plates, any of them designed for the JL that gets installed by mounting to the engine mounts will not fit the Gladiator.

 

[Sruss915]

Ill have to look a bit more it was my understanding that the jt and the jl are virtually the same till you pass the cab section?

 

[highoctane]

Ill have to look a bit more it was my understanding that the jt and the jl are virtually the same till you pass the cab section?

I can tell you That just from looking underneath that the engine mounts are indeed different. There are quite a few differences in the front half of the vehicle when compared to a JL.

Sponsored