Sold: North Carolina SOLD

[NC_Gladiator]

I have two Baja Designs LP6 pros For sale. I had four on the front of my old truck, and think the Gladiator looks better with only two.

$650 obo

Sponsored

 

[CTFriel]

I’m in NC as well. Do you have a picture you can send me of what they look like mounted?

 

[NC_Gladiator]

I’m in NC as well. Do you have a picture you can send me of what they look like mounted?

Yeah absolutely, these are the other two I have mounted.

 

[RalphTuttle]

I see you don't have a Bull Bar above your winch. I have the same set-up (I have a Rubicon steel bumper on my Mojave)but I guess I will need to remove the Bull Bar in order to mount the lights at that location..... Did you have to drill a couple of new holes in the bumper to mount the lights??

 

[NC_Gladiator]

I see you don't have a Bull Bar above your winch. I have the same set-up (I have a Rubicon steel bumper on my Mojave)but I guess I will need to remove the Bull Bar in order to mount the lights at that location..... Did you have to drill a couple of new holes in the bumper to mount the lights??

So you’ll have a couple of mounting options. If you have a mid or high rise bull bar, I have seen other rigs with these that clear them and you just use two of the existing bolts on the front of the bumper, no drilling required. If you have a low rise, I can take some measurements to see if they will clear it or not. If they don’t, I’ll link some Baja designs tube mounts below I have seen used (they have different versions for different tube diameters).

https://www.bajadesigns.com/products/led-horizontal-mount-1-5.asp

 

[RalphTuttle]

So you’ll have a couple of mounting options. If you have a mid or high rise bull bar, I have seen other rigs with these that clear them and you just use two of the existing bolts on the front of the bumper, no drilling required. If you have a low rise, I can take some measurements to see if they will clear it or not. If they don’t, I’ll link some Baja designs tube mounts below I have seen used (they have different versions for different tube diameters).

https://www.bajadesigns.com/products/led-horizontal-mount-1-5.asp

It appears as if you mounted the the lights using only the center hole in the bracket provided with the lights. Is that correct? If I use one of the Baja mounts, it also will only attach to the center hold in the bottom of the bracket...

 

[NC_Gladiator]

That is correct. I’ve had up to four of these mounted on multiple vehicles that were run for thousands of miles and plenty off-road and they never budged. If that is of concern, then drilling may be required.

 

[Fercho06]

Would you do 450 shipped to san Diego CA? Thank you

Sponsored