Nooks and crannies

[Wowed777]

Have you guys found good ways to clean all these tight areas? I have tried blowing air from a compressor, brushes, water, edge of towel, etc. there are so many of these areas it’s impossible! What have you guys used successfully?

Sponsored

 

[Glad Jeeper]

It was very frustrating how much stuff got in there. After cleaning it out, air, medium pressure water I installed the following:

https://www.amazon.com/gp/product/B00NL4DI2E/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&th=1

 

[Wowed777]

It was very frustrating how much stuff got in there. After cleaning it out, air, medium pressure water I installed the following:

https://www.amazon.com/gp/product/B00NL4DI2E/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&th=1

Thanks I might try this. It’s held in place just by pressing in?

There are so many of these spaces on the gladiator. The hood grills, wiper grills, even the small lip right under the windshield.

 

[Glad Jeeper]

Thanks I might try this. It’s held in place just by pressing in?

There are so many of these spaces on the gladiator. The hood grills, wiper grills, even the small lip right under the windshield.

Yes it is held in by pressing it in. If I remember correctly there is good instructions.
The only issue I did have was in 5 degree cold and there was a little ice / snow that built up a little and pushed it out of the groove.

 

[Gvsukids]

Have you guys found good ways to clean all these tight areas? I have tried blowing air from a compressor, brushes, water, edge of towel, etc. there are so many of these areas it’s impossible! What have you guys used successfully?

https://www.jlwranglerforums.com/forum/threads/jl-fender-gap-collects-debris.17512/

 

[HorneyBadger]

I tried it and the tubing comes loose occasionally. Especially on the front leading edge and the rear fenders.

Sponsored