Search results

Thanks for the photos, really shows how crazy bright the headlights are... even though I can see what you mean about filling in the surrounding areas. Definitely thinking about these more, however I am also thinking of keeping the stock fogs and going with the BD6 Amber mounted on the bumper...

Photos of the finished install would be awesome, I was eyeing the rear bed area as well, looking forward to seeing how this goes...

makes sense... thank you.

As I found out when I had my switches installed, the dealer installed aux switches did not come with the two additional wires (BATT & ACC). However looking at the fuse diagram, BATT is fused by F72 10AMP and ACC is fused by F50 10AMP, so my question is, if I were to use an Add a Fuse pigtail...

That looks great... those KC Hilite G4's look way better than I was thinking they would. Do you run them with the headlights on? If so do they over power the headlights or just fill in the view so to speak? Thanks for attaching the photos, this is helping me to decide my overall lighting...

I was/am considering this one, can you upload some pics, preferably side shots, I am wondering how much of the bed it takes up. Thanks.

As I found out, the dealer installed aux switches did not come with the two additional wires (BATT & ACC). However looking at the fuse diagram, BATT is fused by F72 10AMP and ACC is fused by F50 10AMP, so my question is, if I were to use an Add a Fuse pigtail and run a wire along the aux wire...

That has to be the most used AUX switches I have seen yet... I wasn't really considering the overhead MOLLE panel, but after seeing yours I can for sure see some possibilities. Thats interesting, never thought to break it up by side... sometimes all you need is one area lit up. Thanks for...

Old thread, but this is something I have been looking at for options to install OBA, just not sure about the wire route and how it would hold up to water spray from daily driving and or offroad adventures, but it is on a skid plate...

6 Switches would have been great, I had the dealer add my switches so I do not have the extra two wires that are factory installed, if I did then the BATT and ACC wires would be used for a CB (ACC) and Dash Camera (BATT), wish JEEP would have added those wires to the wire looms they sell for...

Most likely this will be the route I end up eventually taking...

I felt this was general enough to not list in the technical section... if a moderator deems it not, then please move as appropriate... So for the aux switches what is everyone running on them? Especially the higher AMP ones rated at 40AMPS, I don't think I have any plans to install anything...

Sounds great, appreciate it.

Would you happen to have a night shot of these KC G4 Ambers? I am thinking of installing these in place of my fogs, but can not seem to find a good night picture of the amount of light they throw. Thanks.

I just ordered these as well and received the same ones as you did, although the inside of mine is stamped MOPAR 82215427AB also dated 2019

Slightly noticeable.... LOL Yeah, I'm thinking I might have to add these to the list.

Might have missed it but did you post a picture of them at night?

My switches were installed after the purchase by the dealer... IIRC you had issues getting yours flashed, might be an issue still relating to your install and or flash procedure.

Just verified, my switches do dim to match the dashboard, and are adjustable via the interior dash switch.

Anyone have experience using the waterproof solder style connectors? (Could not get the photo to post, but a basic GOOGLE search will yield the pictures) These are available in many different quantities on AMAZON. Really like the idea of a self sealing connector that also "solders" the...