Search results

UPS to SC is $27.32. Drop me a pm if you want it. I have Venmo or PayPal.

Fogs and markers are pending payment. I’ll update if it falls through.

Yes, no problem at all.

yes it will come color matched.

It’s all over the place. I’ve seen as much as $3500. What are you wanting? Here’s what mine looks like with drop down front slider, side slider windoors, and Yakima tracks.

Winston-Salem area but I’m often in Charlotte through Burlington.

Take offs from a JL that I was going to use but decided to go a different direction. no scratches, etc. Fog Lights - $100 Markers - $200 shipping if you want to pay. P

Rubicon take off suspension. -shocks are sold. (2) front springs $100+ shipping (2) rear spring $100+ shipping Teraflex 0.5” - 1.5” front spacers (no bump stops) $50 + shipping

I have two left from a trailer project that hasn’t materialized. Take-offs with no damage. No TPMS. $125/each. Rather not ship but will on your dime (likely around $35). Chris

ARB

I’m running that Eezi-Awn cab rack and no way I’d run it with only 2-feet per side seem crazy to show it that way. I’m down with the tray bed though.

My questions and comments: Did you install the lift? Have you retorqued your trackbar (most likely culprit)? what wheels and tires are you running and at what air pressure? have you had them balanced? been wheeling and bent anything (tie rod)? had an alignment completed? If so what are...

Alignment check

Absolutely it can handle it. The reinforced caps are a waste in my opinion.

Did you document the fact it was loose with the dealer? If so, stick a socket on it and see if it will tighten down. I installed my ACE sliders by myself in less than an hour. It was an ultra simple job with hand tools no impacts. I’m guessing they got scared when the bolt was almost out but...

not to argue but a “pro” will get your wheel no more center than you could with an OBD JScan, socket set, and channel locks. Then you can make a lot of tweaks on your own. Centering the wheel cannot be done as a once and done. Not going to happen. You need to get it close (+\- 3*) then drive...

I Had the squeak. Barely noticeable. I run mostly Synergy components because they’re made in the ole USA. An angle grinder and a flap disk clearances the mount about 1/16”. Took longer to plug it in but to each his own.

The quality of Eezi-Awn is tough to beat. I’ve also ran a lot of tents (ARB,CVT, Tepui, Roofnest, GoFSR, Eezi and probably a few others). I prefer the fold out style for a number of reasons but the hard shells seem to be the norm for now. Eezi-Awn Series 3 1600 on an ARE shell. Also added a...