Cargo Cam wiring help w/Tygr sport bar

[Matts4313]

Hello all,

I am throwing a few extra cameras in with the JL4001. 2 of them will be mounted in the stubby bumper I am installing as rock cams, but I want to put an extra Camera facing the back/bed of my truck for towing purposes or whenever I have the tail gate down. My issue is, I dont know a good/pretty way to run the wiring? Additionally, and thoughts or advice on where and how to mount this would be appreciated!!

Sponsored

 

[willys 41]

I am very interested to know what you think about JL4001 screen compared to the JL3001
I have had the JL3001 in my Willys for over a year now and have had lots of problems with the reflecting and glare in the Screen
I have tried at least 5 different anti glare films with out much luck
Please let me know what you think
I will replace my JL3001 with the JL4001 if the screen issue has been solved
Thanks
Larry

 

[ShastaJT6]

You could drill and use self tapping for mounting the camera, drill a hole in the roll bar for the wire to feed in. Put another hole at the bottom for an exit point, touch up paint and grommets, split loom, etc, bobs your uncle.

My Black Horse roll bar uses this setup for the 3rd brake light wiring. If you have gotten any packages recently, the plastic banding makes for a great wire fish - feed it through and then tape your wire to the end, then pull it back out.

 

[willys 41]

Here is some pictures of the JL3001 under different conditions
As you can see the refection can be very unreadable
This is with the best anti glare fill I can find
I am hopping that the JL4001 has a much better screen
On my other Wrangler with the factory 8.4 there is no issue with glare

Sponsored