Changed battery did bypass no start

[Taker73044]

2022 gladiator, Had a fail start issue about a week ago. My main battery died. I replaced the battery and it seemed to fix my issue for about two hours. And then I had a no start issue. I would push the start button dash lights were powered on but, Nothing would happen not even with a jump. So I did an auxiliary battery bypass pulling fuse 42 and disconnecting the negative cable to the auxiliary battery. My jeep still would not start. So I left the battery cables disconnected for about 20 minutes came back out, hooked them back up and the jeep started right up. This worked for about three days and now it’s doing it again with the auxiliary still bypassed I pushed the start button nothing, no warning lights no check engine lights. The system seems to be going through the steps to start just not starting.I am going to test the main fuse array when I get off work, but if anybody else has any other suggestions to look at while I’m doing this let me know.

Sponsored

 

[Taker73044]

Update just got home from work. Check the voltage at the fuse array all the terminals have power. Went to get into the jeep and start it and it started right up . Idid not disconnect battery or anything like that(it would not start this morning dash powered on pushed the button nothing happened.) A few days ago when I had this problem, I had to disconnect the battery for about 10 minutes before it would start. So if anyone has any ideas that would be great.

 

[bd100]

Battery terminals clean and tight?

Sponsored