elocker for 3.73

[Yona]

I have access to both front and rear elockers (oem) and 4.10 gears inside. Can i just pull the elockers and use those with my 3.73s or do i need to keep them with the 4.10s and IF i keep them together do i need a install kit to replace my 3.73s
I have a HA so wide track m210 and m220 already but im not a big fan of drilling the pumkin to run wires but the rear donor will work but the front donor broke at the fad so its a no go.

Sponsored

 

[Wheelin98TJ]

You could use your 3.73 gears. There are no carrier breaks with the Dana 44 Advantek axles.

You'll need an install kit with whatever ratio you decide on.

 

[Yona]

dam so not just a unbolt locker, bolt in locker,
and drill a hole lol

 

[Yona]

I wonder if anyone has used factory lockers as a drop in instead of using the whole axle

 

[Wheelin98TJ]

dam so not just a unbolt locker, bolt in locker,
and drill a hole lol

Unfortunately not.

Gears are setup with thousandths as tolerances and you'll see thousandths differences between different carriers/lockers.

Sponsored