Fox 2.5 with DSC, Adjustments

[JTGuy]

Just looking for some advice on what people have set the adjustments at on the FOX 2.5 Performance Elite with remote res and DSC adjust . Great shocks with high and low speed adjust. They were tuned by Accutune but still need to do the adjustment on the reservoir.

Sponsored

 

[JTGuy]

I may have found a sweet spot. 3 clicks in on fast and slow adjustments. Might not be perfect but around town it isn't bad.

 

[JeepOfTheseus]

Don't be afraid to try a wide range of settings. I don't recall exactly where mine are, but LSC and HSC are at different values, and are also set differently front to rear (sides match). I do have a bit of weight over stock, though, so what I found necessary (or rather, to my liking, because that's what ultimately matters):

Higher LSC, and biased toward the front, to keep things a little more firm with cornering/roll.
Lower HSC, biased toward the rear, to absorb bumps, especially with the heavy load.

 

[JTGuy]

Just got the rears today. Instructions say to install with the remote res forward. That will put the adjustment knobs in a more difficult location to adjust. Is there a reason for it facing forward?

 

[Shamus]

The original instructions I had(2021) said to install with the res Rearward, But the jeep shop that did the alignment after the lift changed them and installed them forward. Then After having the all the shocks tuned I installed them rearward again and have been running for 10K without any issues. I'm guessing it is a clearance issue with some lifts / tire combos. I do like the knob being easier to access.

 

[JTGuy]

Spoke with Fox. The res is clocked a little off of straight and can be readjusted to allow a rearward position. I'll think about it but I tend to not want to mess with them.

Sponsored