Gladiator rear quarter panel protection

[Blade1668]

I did not do a write up. Having a template for the bumper would have been great. I used masking tape to create my cut lines and it worked fine but I probably would have cut less a little less off the bumper if there was a template in the box.

I'm pissed at myself for following the instructions, I didn't need to cut anything but a notch out on each side.
As you can see in the pictures I trimmed the right side following directions. On left side I just cut away to fit. Until the box cutter handle split.

Sponsored

 

[Wyofuy069]

Hi guys, I have a new Mojave and the wheels are flicking outside the flares on both the doors and the rear quarter panel. I would not mind the steps, but I have the factory rock rails (?) which do nothing. If there nothing available for the flares that people have seen. As for the steps, do you know of any that do not require removing the rock rail? My last Jeep (14 Wrangler) I replaced the rails, but the exposed metal under the doors is very unsightly to me and I was unable to keep both because of fit on one corner only....

I just installed the Romik Ral-T. It does replace the sand rails, but it is also lighter and will hopefully keep rocks of the rear wheel wells.

 

[Uparms]

Looking for information/products on protecting the rear quarter panel between the tires and bumper. I did a search in the forum, but didn’t find any information. So if I missed it please point me in the correct direction.
I like the Redrock 4x4 Bed Slide Rock Rails. The price seems reasonable @ $190, but they have been out of stock for a long time.
Any other suggestions?

I bought the Red Rocks and love them, Handles my fat ass any day as a side step. Go slow on install, watch the artwork, there is a Left and right on the mount brackets that attach to the step/rail. Price slowly moving up. They will be here same time as your next born or you families next born. Wait it out, cheaper then the Mopar and damn nice product. Read the other installs for the trimming of bumper. Even my night rushed hack job with a cutting wheel did not turn out too bad.

Sponsored