Mopar Lift with level Different Shocks Needed?

[BSW520!]

Hello All , I have 21 Willys JT gas.
with Mopar lift springs and Teraflex level ( got a great deal on new springs, control arms, correction brackets, ) I already did teraflex level on it last fall. But looking at shocks I was thinking Bilstein would I be wrong to think I would need 3-4” lift shocks for the combo of spring and level probably only going to retain the 1” just spacer just want more of leveled look. I also plan on doing steer smart fr and rear track bars. Thoughts ?

Sponsored

 

[Wheelin98TJ]

Will you have just the 1" spacers in the front and no spacers in the rear?

Ideally you'd install the coils plus the spacers you want to keep and take some measurements. Then compare to the compressed measurements of the shocks you're considering.

 

[BSW520!]

Will you have just the 1" spacers in the front and no spacers in the rear?

Ideally you'd install the coils plus the spacers you want to keep and take some measurements. Then compare to the compressed measurements of the shocks you're considering.

No spacers in rear just the mopar lift springs.
Just 1” spacers in front plus the mopar springs.

 

[Wheelin98TJ]

No spacers in rear just the mopar lift springs.
Just 1” spacers in front plus the mopar springs.

You're probably pretty close with your thinking on needing shocks for 3-4" lift.

You should end up with about 4" lift in the front and 3" in the rear.

 

[BSW520!]

You're probably pretty close with your thinking on needing shocks for 3-4" lift.

You should end up with about 4" lift in the front and 3" in the rear.

Thanks Wheelin!

Sponsored