Pedal Commander left on during service

[Mister Lamb]

Very upset with myself..

Took Jeep for last free Oil Change @ dealership and being it was a hectic day left my Pedal Commander on without thinking.

They ended up performing a software update and now I've got 'Service Throttle Control' and 'Service Electronic Stability Control and a CEL.

Will removing the Commander and removing the Negative on my battery for some time be enough to get the computer to reset?

Do I have to take it back in?

Sponsored

 

[Mister Lamb]

Cmon no one?!

 

[Killroy Was Here]

Cmon no one?!

Might want to call Pedal Commander to see if they have run into this before.

Just a thought.

Dave

 

[Lunentucker]

I'm guessing the Commander is now just not "married" to the new firmware properly and likely needs to be reinstalled. But that phone call is your best bet

 

[Chief_jeep]

I uninstalled mine when I got a bunch of error codes and haven’t had a problem since. Cleared the code with the idash after the pedal monster was uninstalled.

 

[Mister Lamb]

I uninstalled mine when I got a bunch of error codes and haven’t had a problem since. Cleared the code with the idash after the pedal monster was uninstalled.

Were you ever able to clear the 'Permanent' codes from your ECM? I cleared all the errors + CEL in the truck but still have the permanent code when the scanner is hooked up.

 

[Chief_jeep]

Were you ever able to clear the 'Permanent' codes from your ECM? I cleared all the errors + CEL in the truck but still have the permanent code when the scanner is hooked up.

not sure which permanent codes you’re referring to. Mine didn’t go to the dealer with it on but I was able to clear all the codes with the idash. Also, I permanently uninstalled mine and havent had an issue since. Hopefully you can get it figured out!

 

[Jclow801]

What ended up happening OP?

 

[Mister Lamb]

What ended up happening OP?

Took the pedal commander out til all the codes cleared, re-installed and after a week the truck went back into limp mode and threw all the same codes.

Pedal Commander Support has sent me an update specific to my PC that I've yet to get around to installing via the app.

Has been out since but I do intend on re-installing and updating one of these days.

Long story short the truck is fine

Sponsored