DRCRGuy
Active Member
- Thread starter
- #1
Hi all, would really appreciate some help. This past weekend I disconnected the negative/positive terminals on my battery to install new rubicon dash panels. I reconnected everything, all is tight except the nut on the positive terminal just spins rather then getting tighter or looser. First, is it normal for this to spin (the nut in question is the one being pointed to in the pic). Otherwise, is it stripped? And if it’s stripped/loose will that cause a check engine light to appear? It was fine a few days until a remote started my truck this morning and the remote cut off with “remote start disabled” notification on the dash.
Sponsored
