Many thanks for clarifying my friend! ... it was for sure the angle of the photo ...Must be the angle of the picture, there's about 10mm clearance at the end where it looks like it's touching. Closest touch point is 3mm at the center, but seems like plenty.
Looks good! It does seem like something's missing, and I would guess it's a skid plate. Hard to tell what you have there, the hood says Mojave but the tires say Overland? If Mojave, the factory skid plate should bolt back up as is. Any other model, I'm not sure....Need some tow hooks and you'll be cleaned up!Installed mine a d it’s pretty tight but manageable I think. Any idea what I can do to clean up this look? Skid plate I suppose? I sure as ____ don’t want to remove this bumper though. Looks easy on the Intertubes but not so much IRL…..at least for me anyway.
It’s just the Sport model. I’ll look at that plastic skid plate but frankly, for what they cost, I think I’d rather bolt something on.....as long as I don’t have to take the whole bloody thing apart again so that rules out Reaper regretfully. There are tow hooks on the bumper. JUSF hard to see since they’re black.
Seriously? That is awesome and in fact, I might steal that idea painting it; looks sweet. I’ll order it straight away.I dont have their bumper, but I do have the Immortal Skid Plate by Reaper. This thing is SWEET. The way it installs is pretty slick, nut plates in the frame rails and using existing fastener points on the vehicle. I did NOT have to remove my front bumper or do any drilling etc to install this.
I DID spray it down with some Raptor bedliner before install to get the red accent, but I am super happy with this thing. Definitely want to show some love for these guys. USA made, quick communication, Ive chatted with them on Insta, etc.
Honestly, this thing is great. I wanted to ditch the plastic one that came with the truck, but was kicking myself for not doing it before the bumper swap.. it was great that I didnt have to screw with the bumper to install this later on.
Nice. I'll have to order a skid plate because mine is just a sheet of plastic. It seems to lack connection points found on the old bumper so it's pretty much junk to me. Yours looks great; gotta get a winch.I have the same bumper. It is tight to the grill, but not touching. Factory fogs and skid plate work fine with it. I actually ordered the skidplate as well but they were out of stock long enough I canceled the order.
I also put the Smittybuilt 10k X2O winch on it. It's pretty tight, I had to ziptie the wiring so it wouldn't rub on the grill. The whole thing is a little weighty, but I love this one.
Love this bumper, ready to pull the trigger on one for my Mojave. Did you have to remove the skid plate for the install?? thanks!I did, install was fairly easy. No modification was needed to the skid plate. I liked the look and it's pretty solid and beefy. I'm very pleased and recommend!
