Wheezy
New Member
- Thread starter
- #1
Sorry this sounds so dumb, because it kind of is. Looking for some wiring help. Did an axle swap for curries. Used Tazer mini and the Z automotive Locker Cables. Front end is perfect. Rear end, getting all kinds of lights and codes and nothing works. Essentially, the codes and errors are like the locker and abs sensors aren't even plugged in. I'm thinking the harness got "pulled" hard enough to damage / disconnect it OR it got pinched bad enough to damage.
Any suggestions on how to trouble shoot this? How to test continuity for those systems from up front to at least test the theory?
Any suggestions on how to trouble shoot this? How to test continuity for those systems from up front to at least test the theory?
Sponsored
