Some issues with my jl mini tazer

[Kulahpac]

Ok. I just got this thing so these are probably dumb questions but here goes....

1. I'm trying to get the "in motion setting" in the live settings to save so I can use navigation while driving but it seems to keep going back to default and not saving... hence not allowing me to use navigation keyboard while moving. Not a big deal because I rarely use it. Just kind of wanted to get it to work because supposedly I can.

2. Next question is in regards to the brake assisted turning everyone keeps talking about. I don't see the setting for it anywhere.

3. I also don't see anything for mapping out buttons to set up buttons to do certain tasks.

Any help would be appreciated.

Updated the device when I got it and it is currently at version 11.3.7

Thanks

Sponsored

 

[sass JT]

I hope you read the owners manual. There’s some great tips in there… I’ll drop it right here for you just in case.

https://www.zautomotive.com/zpu/instructions/TazerJLMiniUserGuide1137.pdf

1. Per manual
Set In-Motion Nav: If set ON, this
adds the ability for address info to be entered into the navigation system while vehicle is moving. This is for the
PASSENGER to use. It may be illegal for the driver to use the navigation system to enter information while the vehicle is in motion. It is recommended to leave this setting OFF, enabling it only when you need to use it, as it
can cause an occasional radio reboot right after engine start-up. This will automatically be disabled if TurnCAM is enabled.

2 & 3… The turn assist is a live button function and must be mapped to turn it on.
Per the manual,
Button Remap: This function allows
the assignment of “hotkeys” for quick access to some of the Tazer’s functions. The cruise +/-/RES may be used for this function. While the dash is in Audio mode, press and hold the RIGHT arrow and press the button you’d like to remap. The choices are:
Any of the 8 light shows Backup camera
TC Kill (excl. 4XE)
14

Line Lock (excl. 4XE)
Rock Crawl (excl. 4XE)
Turn Assist (excl. 4XE)
Winch Mode (excl. 4XE) Cooldown Front/Rear/Front+Rear Lockers SwayKill
Dark Mode
Force RWD
Keep in mind that not all functions pertain to all vehicles. These remap buttons will only program and operate while Cruise
Control is OFF. When Cruise is on, they will operate as normal cruise control buttons. For TC Kill, a vehicle restart is required
to bring the system back to normal. For Lockers, the normal Locker off button disengages the lockers.


Don’t forget that you need to do one full reboot and 2 sleep cycles. Follow their directions completely or things don’t like to work

i hope this helps

 

[Kulahpac]

This did help actually. Thanks. I had the manual but I didnt realize there were different versions of it. The version I downloaded must have been an old one and had no Gladiator related info.

 

[EddyArnold]

Here's a good vid on the remapping

Sponsored