SR1 Bed Rack by Exceed Fabrication

[snazzi_scarlett]

If yall need a tester, lemme know!
Instagram.com/tipsy_jt

Sponsored

 

[Exceed Fabrication]

If yall need a tester, lemme know!
Instagram.com/tipsy_jt

Thank you for your interest in our products! I will PM you if I need anything!

 

[Exceed Fabrication]

Some views from the cab looking back. The low bed rack will inevitably block the view, but the benefit is lower wind resistance and easier access to the garage (especially with RTT)

 

[Exceed Fabrication]

More photos for reference

 

[Exceed Fabrication]

Some details of the SR1 bedrack. Next, we will sand down the raised parts where the welds are, while retaining strength and neatness.

 

[ArmyMP]

This is the rack I need.

 

[snazzi_scarlett]

Looks amazing! can’t wait

 

[ArmyMP]

Any word on the status of release? I know you had said april-may. Just curious if we are finalizing a date

Thank you

 

[Exceed Fabrication]

Any word on the status of release? I know you had said april-may. Just curious if we are finalizing a date

Thank you

Hey Tom, sorry I’m at the show recently, it’s expected to be available before April 15th!

 

[ArmyMP]

Any updates?

 

[ArmyMP]

...

 

[Exceed Fabrication]

...

Sorry for the delay, it’s a headache for me too... I’ll check the logistics progress again on Monday!

 

[Exceed Fabrication]

Any updates?

Now available!
Place your order via link: https://exceedfab.com/products/sr1-bed-rack

 

[JTdiRtyD]

Man, I kind of wish I had seen this before I ordered a Rebel Offroad half rack. I received half of my rack but I'm STILL waiting on parts from them and it's been almost 2 months. Been excuse after excuse.

I went with the Rebel because it is relatively easy to enclose, but yours looks like it would be even easier because you use full length pieces for both top and bottom that would make sealing it very easy. Any future plans to offer optional enclosure panels?

 

[Exceed Fabrication]

Man, I kind of wish I had seen this before I ordered a Rebel Offroad half rack. I received half of my rack but I'm STILL waiting on parts from them and it's been almost 2 months. Been excuse after excuse.

I went with the Rebel because it is relatively easy to enclose, but yours looks like it would be even easier because you use full length pieces for both top and bottom that would make sealing it very easy. Any future plans to offer optional enclosure panels?

Are the optional enclosure panels you are referring to the molles on the side?

Sponsored