Under The Sun Vinyl Vent Decal

[Flexin]

Has anyone install these decals? I have them on and lined up great. I can't seem to get the application tape off. I am guessing there is a clear tape over the display side of the decal. Any help or advice is appreciated.

I did the wet application and again, that made lining it up easy. It's been two hours, should I just leave it overnight and try with some technique tomorrow? I spray the solution on but it does not seem to soften up or allow me to peel it off without the decal coming up.

Sponsored

 

[Moab]

Pic?¿ There usually is a release film the decal is adhered too.

 

[ACAD_Cowboy]

A backer, the decal and then the top cover so you can manipulate it around etc.

 

[Flexin]

Here we go

 

[Flexin]

Here we go

It came on the backer, I believe there is a clear coat film over it making it shiny but it’s cut to shape and I still can’t get it off.

 

[Moab]

Not knowing what kind of finish coat your decal should have...most of the transfer tape I have used was similar to a “soft” flexible masking type tape. I have seen clear as well. My only suggestion is warm soapy water applied again and see if you can manipulate the sticker and or find the edge of clear tape, if present, maybe use a soft plastic scraper and see if you can lift any tape without disturbing the decal. Could also try painter tape just place a piece on edge of decal and see what “lifts “ with it. Just an edge . Want to avoid ruining the decal.
May the force be with you!

 

[Flexin]

I found out from the vendor this morning although the instructions provided say it has a clear on the application side, mine does not and they need to make this correct in the directions.

So note to folks, check with them before to ensure it does or does not. I'm glad I stopped messing with it, but, I used a piece of plastic to squeegee it and it has light scratches. I did this since I thought there was a clear on top to be removed.

Sponsored