Wiring harbor freight 4" edge road lights (pulse modulating) to factory installed AUX switch.

[KratosTHEgladiator]

Hey everybody, I was wondering if anybody has wired the harbor freight edge road lights (4"pods) up to the factory AUX switch? I'm trying to figure out how to utilize the wiring harness that is specific for these lights since I bought it already. The lights are pulse modulating is my issue. They have a low beam and a high beam. They came with a 5 pole relay. I've powered the lights with the harness already to test them out at night, but that's with the switch they provided in the wiring harness and hooking it directly to the battery. I'd like to use the factory AUX to run low and high beam. Maybe I have to use 2 different AUX switches to do this? Thanks for any input guys!

Sponsored

 

[KratosTHEgladiator]

I got it figured out!

 

[Bbannongmu]

the suspense… what did you end up doing?

 

[JeepOfTheseus]

the suspense… what did you end up doing?

https://xkcd.com/979/

 

[dirty red label]

I got it figured out!

Yes, what did you end up doing?

 

[In3briatedPanda]

i am curious to know if you wired the accessory wire to another switch. my kc lights were like this but i left the accessory unhooked bc i did not need the 'dimming' function.

a dual mode switch is possible with the aux switches, ive only done it in testing and wired up a dual switch to two aux switches. one power wire went to aux 3 and the accessory wire went ot aux 4.

Sponsored